Thermador S302 Manual Do Utilizador

Page 7

Applies to C271, C272, C301, C302, CM302 and CJ302
models only.

Your oven has been preset to be hooked up to 240V.

1. Turn off the oven(s).

2. Open the upper oven door.

3. Press and hold the UPPER OFF pad in a double oven or
the OFF pad in a single oven.

4. While the UPPER OFF pad or the OFF pad is held down,
press the CLEAN pad .

5. 240 will appear in the temperature digits. Release all
pads.

6. Touch CLEAN and 208 replaces 240 in the tempera-
ture digits. This will toggle with touches of the Clean pad.

7. To complete the change, touch UPPER OFF or OFF.

Note:  When power is first supplied to the unit (and the
door is unlocked), the CLOCK will flash. Set Time of
Day  as described in the Care and Use Manual. If the
door is locked, the LOCK symbol will light for a few
seconds while door is automatically unlocking and
CLOCK will flash.

Note: Removing the
door for installation
reduces the weight
of the oven by 30 lbs.
(14 kg) per door.

To Unlatch
and Close
Door

Position of
Hinge Latch
to remove door

Collar

Hinge Arm

➞

➞

Anchor flexible metallic conduit to conduit box with
suitable box connector.  Connect power supply leads to
oven conduit supply leads, being sure that neutral wire
is connected to white wire.

Remove the bottom trim from the top of the unit.
Remove the base skid.  See Fig. 1.  Slide the oven into the
opening being careful not to scratch side trims.  Secure
oven with the screws supplied through the side of the
front frame into the cabinet.

Note:  To secure the oven to the cabinet, use the 4
screws provided (2 each side).

For ease of installation, some oven door(s) may be re-
moved to reduce the weight of the oven by 30 pounds per
door.  To remove the door, open the door and hold it all
the way open.  Close the hinge latches  See Fig. 5.  The door
can now be removed by gently lifting and pulling the door,
(including the hinges) up and out of the frame.

IMPORTANT:  Reinstall the door very carefully.  Be
certain that the hinge arm does not hit the porcelain collar
around the clearance slot or it will chip the porcelain.

CAUTION: THE DOOR OF THE CM301
AND THE UPPER DOOR OF THE CJ302
AND CM302 ARE NOT REMOVABLE.

After installing the unit, replace the door(s), be certain
both hinge arms are well inserted and secure, and that the
hinge latch is fully released.