Epson equity 320sx plus Manual Do Utilizador

When the system has successfully completed its self test, you

see the following prompt:

Do not press any key yet. If MS-DOS has already been
installed on your system, you’ll see a prompt to enter the
date. (For information about loading the operating system,

see your MS-DOS manuals.)

If there is no operating system on your computer, you see an
error message. Ignore the message for now. Follow the
instructions below to turn off the computer and then go on
to Chapter 2 for instructions on running the SETUP program.

If your computer’s configuration does not match the
information stored in the computer’s CMOS RAM (defined
through the SETUP program), you see an error message

and a prompt to press the 

key. Press 

to continue.

Then run the SETUP program to correct the information.

(See Chapter 2 for instructions.)

When you are ready to turn off your system, reverse the

sequence of steps you followed to turn it on. Turn off the

computer first, then turn off the monitor and any peripheral
devices.

Now go on to Chapter 2 and follow the instructions to run

the SETUP program.