PAC swi-rc Manual Do Utilizador

06-18-10

  Universal Steering Wheel Control Interface

• Please visit 

http://www.pac-audio.com/swixprogramming/swixprogramming.asp for the most current list of 

compatible vehicles.

• If possible, install the SWI-RC while you are installing the new head unit. Keep in mind you may need to plug in the 

factory stereo to locate certain wires; therefore do not complete the head unit installation until the SWI-RC is work-

ing properly.

• Plan a general installation location for both the SWI-RC plug and the control body. Keep in mind that the supplied 

wire harness is 

two feet long, and the 1/8" plug harness is three feet long. 

•  Use a multimeter or approved measuring device for checking vehicle circuits.

Pacific Accessory Corporation

SEEK

PRESET AM FM

VOLUME

PLAY

MUTE

Power

Jack for the SWI-RC

Steering wheel

audio control wire

To Kenwood,
OEM or
Blaupunkt
remote control input

For Alpine, JVC, Clarion, Kenwood, 

Pioneer, Sony, Valor, OEM, Boyo, 

Dual, Visteon, Advent & Blaupunkt 

Steering Remote Ready Radios

For Alpine, Clarion, JVC, Pioneer, Sony or Valor radios, connect the SWI-RC 1/8" plug into the radio's Steering 

Wheel input jack on back of radio or wire harness. For Kenwood or OEM  radios, connect the blue/yel wire to the remote 

Input wire (blue/yel or yel/blu for Kenwood, gray for OEM) of radio.

Blaupunkt radios with optional wireless remote inputs are supported by the SWI-RC, however we do not supply 

any connectors or support for Blaupunkt. It is up to the consumer or installer to supply this connector. Use vehicle 

Connector Chart and use VW connector as reference. Connect the SWI-RC's blue/yel wire to pin #11 of VW connector.  

The connector you obtain may come with two of three pieces, however the connector (usually green) should show pin 

#11 on it.