Philips aj6111-37b Manual Do Utilizador
17
English
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
PHILIPS for help.
you are unable to remedy a problem by following these hints, consult your dealer or
PHILIPS for help.
Problem
Solution
Troubleshooting
nocdor Errindication
No sound
The system does not react when buttons
are pressed.
are pressed.
Remote control does not work
✔
No disc inser ted. Insert a suitable disc
✔
Replace/clean CD
✔
CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
Use a finalized CD-R(W)
✔
Moisture has condensed in the player. Remove
the disc and leave the player power-on until the
moisture evaporates.
the disc and leave the player power-on until the
moisture evaporates.
✔
Check whether the set is connected securely.
✔
Make sure the set is not in the MUTE mode. If it
is, press MUTE to turn on the speaker.
is, press MUTE to turn on the speaker.
✔
Check whether the volume on the set has been
set to the lowest level. If it has, turn up the
volume.
set to the lowest level. If it has, turn up the
volume.
✔
CD-ROM disc inserted/CD contains non-audio
files. Use CD Audio discs only.
files. Use CD Audio discs only.
✔
Remove and reconnect the AC power plug and
switch on the system again.
switch on the system again.
✔
Remove the protective plastic tab before using
the remote control.
the remote control.
✔
Reduce the distance between the remote
control and the set.
control and the set.
✔
Replace the battery.
✔
Point the remote control directly towards the IR
sensor.
sensor.
Radio reception is poor
✔
If the signal is too weak, adjust the antenna or
connect an external antenna for better
reception.
connect an external antenna for better
reception.
✔
Increase the distance between the set and a TV,
VCR or radiation source.
VCR or radiation source.
The Clock setting is erased
✔
Power has been interrupted or the power cord
has been disconnected. Reset the clock.
has been disconnected. Reset the clock.
p001-p018_AJ6110_37-Eng
3/3/2006, 16:32
17