Lowrance electronic globalmap baja 840c Manual Do Utilizador

128 

The Restore Defaults command allows you to reset an individual EP-35 

Temp Sensor's settings to factory defaults. If, for example, you execute the 

Restore Defaults command from your Water Temp's Advanced Options 

menu, only the settings for the Water Temp will be reset to factory de-

faults. Other temps on the network will not be affected. 

1. Press 

, use 

↑ ↓  to select 

 and press 

. The 

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-

agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-

chronization.  
2. Highlight 

 and press 

, which will open the Bus Configu-

ration menu. A list of network devices will be at the top of the page. 
3. Select the desired temp sensor and press 

. The Device Configura-

tion menu will appear.  
4. Highlight 

 and press 

.  

5. Select 

 and press 

. The following message will 

appear: Are you sure you wish to change this device's configuration?  
6. Highlight 

 and press 

. Press 

 repeatedly to get back to the 

main display. 
EP-10 Fuel Flow Configuration 

1. Press 

, use 

↑ ↓ to select 

 and press 

. The 

NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-

agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-

chronization.  
2. Highlight 

 and press 

, which will open the Bus Configu-

ration menu. A list of network devices will be at the top of the page. 
3. Select the fuel flow you want to rename and press 

. The Device Con-

figuration menu will appear with the Device Name dialog box highlighted. 
4. Press 

 and use 

↑ ↓, ← → to input the desired name for the fuel 

flow. Press 

. Press 

 repeatedly to get back to the main display. 

1. Press 

, use 

↑ ↓  to select 

 and press 

. The NMEA 

2000 menu will appear with five options: Bus Setup, Fuel Management, 

NMEA 2000 Alarms, Waypoint Sharing and Backlight Synchronization.  
2. Highlight 

 and press 

, which will open the Bus Configu-

ration menu. A list of network devices will be at the top of the page.  
3. Select the desired fuel flow and press 

. The Device Configuration 

menu will appear.