Lowrance electronic globalmap baja 840c Manual Do Utilizador

135 

appear: Do you wish to re-calibrate the device? 
7. Highlight 

 and press 

.  

8. Take your vessel out on the water and burn at least five gallons of 
fuel. Be sure you run only ONE engine — the engine connected 
to your fuel flow.  
9. Fill up your tank again, noting how much fuel you added to the tank. 

Compare that number to the Fuel Used figure displayed on the page 

you customized. If the amount of fuel you added to the tank and the 

fuel used figure are off by more than 3 percent, we recommend the fuel 

flow be calibrated. 

NOTE: 

You must use the gauge's Fill Tank command when filling your fuel 

tank to keep the fuel flow updated with correct information on the 

amount of fuel in the tank. 

10. If calibration is necessary, press 

|

, select

 and 

press 

. 

11. Highlight 

 and press 

.  

12. Select 

 and press 

 to choose the location of the tank 

connected to selected fuel flow. Press 

. 

13. Highlight 

 and press 

. The following message will ap-

pear: Are you sure you wish to Fill Tank? Select 

 and press 

14. The following message will appear: Do you wish to re-calibrate the 
device? Select 

 and press 

.  

15. Repeat these steps for each EP-10 Fuel Flow you want to calibrate. 

1. Press 

|

, select

 and press 

. 

2. Highlight 

 and press 

.  

3. Highlight 

 and press 

. The Engine Select menu will 

appear with up to four options: All Engines, Port, Center and Star-

board. Selecting All Engines will reset calibration for all engines back 

to factory defaults. 
4. Select All Engines or the engine connected to the desired device and 

press 

.  

5. Highlight 

 and press 

. The following message 

will appear: Are you sure you wish to Reset Calibration?