Lowrance electronic globalmap baja 840c Manual Do Utilizador

77 

1. Press 

|

|

↓

 to 

|

. 

2. Press 

↓

 to

|

. The GPS Simulator Menu appears. 

3. Press 

↓

to

 

 

 

Make the desired settings, then turn the simulator on by highlighting 

the 

 box and pressing 

 key. Press 

|

|

 

to clear this menu. A message and tone appear periodically, warning 

you that the simulator is on. To turn the simulator off, repeat the above 

steps or turn off the unit. 
While in simulator mode, you can press 

 to clear the steering and 

speed boxes from the screen while continuing the simulation. This will 

allow you to use the map cursor during a simulation. To turn steering 

and speed boxes back on again, return to the GPS Simulator menu, select 

the 

 command, press 

, then press 

|

|

 to 

return to the previous page. 

Simulating Trail or Route Navigation 
In Simulator mode, your unit can automatically follow a trail or route 

without manual steering if you use these steps: 
1. Go to the simulator menu as shown above. Pick a 

 at or 

near the beginning of your trail/route. Enter an approximate 

 (shown 

in compass degrees) that will point you toward the start of the trail/route. 
2. Set 

 to zero. Select 

 command and press 

, 

which turns on the simulator and returns you to the Map Page. 
3. Begin navigating along the trail/route (If you are close enough to the 

first waypoint, the arrival alarm will usually go off as soon as naviga-

tion begins. Press 

 to clear the alarm.). When navigation starts, 

press 

↑

 to increase speed to the desired setting.