Directed Electronics rk20 Manual Do Utilizador
21
© 2008 Directed Electronics. All rights reserved.
H1/9
WHITE
(+/-) LIGHT FLASH OUTPUT
Important:
Do NOT connect this wire to a negative vehicle
light flash wire before changing the programming jumper to
the negative polarity position or damage to the vehicle light
circuit may occur.
the negative polarity position or damage to the vehicle light
circuit may occur.
As factory configured, the H1/9 WHITE wire should be connected to the (+)
parking light wire. If the light flash polarity jumper is moved to the (-) position
(refer to the Programming Jumper section of this guide), this wire then supplies
(-) 200mA output.
parking light wire. If the light flash polarity jumper is moved to the (-) position
(refer to the Programming Jumper section of this guide), this wire then supplies
(-) 200mA output.
(+) Positive Light Flash Output
(-) Negative Light Flash Output
WHITE H1/11
(+) LIGHT FLASH OUTPUT
WHITE H1/11
(-) LIGHT FLASH OUTPUT
Note: For parking light circuits that draw 10-amps or more, the internal jumper
must be switched to a (-) light flash output. (See Setting the light flash polarity
section of this guide.) P/N 8617 or a standard automotive SPDT relay must be
used on the H1/2 light flash output harness wire.
➤
Remote start harness, (H2) 5-pin connector
H2/1
BLACK/WHITE
NEUTRAL SAFETY SWITCH INPUT