D-Link DGS-1224T Manual Do Utilizador
28
The priority of Gigabit Fiber port is higher than Copper.
To change the port setting, click on the ID parameter to enter to the
selected port to configure its Speed/Disable and Flow control setting.
selected port to configure its Speed/Disable and Flow control setting.
Figure 18.
Speed/Disable:
This setting has six modes—100M Full, 100M Half, 10M Full, 10M
Half, Auto and Disable—for speed or port disable selections.
This setting has six modes—100M Full, 100M Half, 10M Full, 10M
Half, Auto and Disable—for speed or port disable selections.
Flow Control:
This setting determines whether or not the Switch will be handling
flow control. Set FlowCtrl to Enable for avoiding data transfer
overflow. Or it sets to Disable; there is either no flow control or other
hardware/software management.
This setting determines whether or not the Switch will be handling
flow control. Set FlowCtrl to Enable for avoiding data transfer
overflow. Or it sets to Disable; there is either no flow control or other
hardware/software management.
When the port is set to forced mode, then the flow control will
automatically set to Disable.
automatically set to Disable.
Default Priority:
The Default Priority is specific the 802.1P QoS priority level to
related port, all of the received data packet will follow the Default
Priority level forwarding data packet to other port.
The Default Priority is specific the 802.1P QoS priority level to
related port, all of the received data packet will follow the Default
Priority level forwarding data packet to other port.