ONKYO dr-2000 Manual Do Utilizador

64

One of the TV’s
remote control
buttons

• Flashes twice when the programming is

successful.

• Flashes three times if the programming has

failed.

• Flashes six times if the programming is failed

because the data capacity of the
programmable button has been exceeded.
TV buttons whose data size overwhelms the
capacity of the programmable buttons are
unable to be used for programming.

The SEND/LEARN indicator flashes twice, then lights
steadily.
Proceed to the next step within 30 seconds.

• When the factory settings resume, the SEND/LEARN

indicator flashes twice.

• If failed, the SEND/LEARN indicator flashes three times.

In this case, no change has been made to the
programmable buttons.

• If the SEND/LEARN indicator doesn’t light up when you press one of

the programmed buttons, reprogram the button.

• If the remote controller operates only at a short distance or there is

a slow response from the TV, check the batteries.
If the batteries are not weak, the pressed button is not properly
programmed. Reprogram the button.

• If the remote controller remains without batteries for 10 minutes or

more, the programmed data will be erased. In such a case, install
new batteries, then reprogram the buttons.

The SEND/LEARN indicator goes off while
the button is pressed, then lights up again.

Proceed to the next step within 30
seconds.

Press one of the other programmable buttons
within 30 seconds.

If the function is successfully copied, the
SEND/LEARN indicator flashes twice.

Lights up again shortly after going off

Carry out the steps from 1 to 4.
The previous function will be erased when the programming is
successful.

After step 2, press the programmable button you wish to
resume to the factory setting twice.
• When the factory setting resumes, the SEND/LEARN

indicator flashes twice.

• If failed, the SEND/LEARN indicator flashes three times.

In this case, no change has been made to the
programmable button.