ONKYO TX-DS494 Manual Do Utilizador
27
Input source signal format
Analog
PCM*
4
Dolby Digital*
5
dts
MULTI CH*
6
Source software
Tape, Record,
CD, Audio DVD,
Video DVD, LD,
CD, LD,
Video DVD
Tuner
Video DVD
Digital satellite
Video DVD
Listening mode
broadcast
STEREO*
1
●
●
●
●
PRO LOGIC II*
2
●
●
●
DOLBY D
●
DTS
●
ORCHESTRA*
3
●
●
UNPLUGGED*
3
●
●
ALL CH ST*
3
●
●
MULTI CH
●
Relationship between input sources and surround modes
The surround modes that can be selected are variable depending on the signal formats employed with the input sources.
Input selector
STANDBY/ON
OFF
ON
POWER
PHONES
MASTER VOLUME
BASS
TREBLE
AV RECEIVER
TX-DS
494
FM
AM
PHONO
C D
TAPE
VIDEO
1
DVD
A
B
SPEAKERS
DIMMER
SURROUND
DTS
/
VIDEO
2
VCR
AUDIO
SELECTOR
LISTENING MODE
DSP
STEREO
DISPLAY
STANDBY
SP SEL
TUNING
PRESET
MEMORY
SW MODE
DIGITAL INPUT
FM MODE
CLEAR
RC-443S
REMOTE
CONTROLLER
INPUT SELECTOR
MODE
SLEEP
DIMMER DISPLAY
CD
TAPE
PHONO
TUNER
D V D
VIDEO 1 VIDEO 2
SUR MODE SW MODE AUDIO SEL
TUNER
PRESE T
STANDBY/ ON
STANDBY/ ON
DISC
MUTING
DVD
CD
TAPE
VOLUME
TOP MENU
MENU
CH SEL
RETURN
SETUP
TEST TONE
LEVEL
E N T E R
LEVEL
5/∞
TEST TONE
INPUT SELECTOR
CH SEL
DSP
STEREO
Ÿ/DTS SURROUND
*1
Only STEREO can be selected when SP SEL is set to 2 ch, when SPEAKERS B is selected or when headphones are used.
*2
When SP SEL is set to 3 ch, “3 ST” is displayed in place of “PL II”.
*3
These modes cannot be selected when SP SEL is set to 2 ch or 3 ch.
*4
Only STEREO can be selected when the PCM source has been recorded with a sampling rate 96 kHz.
*5
Only DOLBY D (PL II if the source is a 2-channel source) or STEREO can be selected when Dolby Digital surround audio is reproduced.
*6
The surround mode cannot be selected when MULTI CH is selected.
Selecting DOLBY PRO LOGIC II surround
1. Press an input selector button to select the
desired sound source.
2. Press the
Ÿ/DTS SURROUND button repeatedly
to select DOLBY PRO LOGIC II.
The selected mode appears in the display. Each time you press
the button, the surround mode changes as follows:
the button, the surround mode changes as follows:
3. Play the selected sound source.
You can adjust the level of each speaker.
1. Press the CH SEL button on the remote controller to select a
speaker.
2. Press the LEVEL
5/∞ buttons on the remote controller to
raise or lower the level.
• The speaker levels set here are cleared when this unit is set to
STANDBY. (The speaker levels return to the levels set using
the test tone.)
the test tone.)
• When the TEST TONE button on the remote controller is
pressed after the above adjustment, the set levels will become
the levels adjusted using the test tone by overwriting the
existing ones.
the levels adjusted using the test tone by overwriting the
existing ones.
To enjoy Surround mode