Hitachi cl32pd2100 Manual Do Utilizador
DO NOT remove any fixed cover as this
may expose dangerous voltages.
DO NOT position the plasma screen on top of
the AVC unit as it could cause damage to the
unit.
4
television safety
safety aspects
This plasma television has been designed and manufactured to meet international
safety standards, but like any electrical equipment, care must be taken if you are to
obtain the best results and safety is to be assured.
safety standards, but like any electrical equipment, care must be taken if you are to
obtain the best results and safety is to be assured.
DO NOT continue to operate the
equipment if you are in any doubt about it
working normally or if it is damaged in
any way - switch off, withdraw the mains plug
and consult your dealer.
DO be careful with any glass panels or
doors on equipment.
DO consult your dealer if you are in any
doubt about installation, operation or safety of
your equipment.
DO place your TV on a flat surface, or if
supplied, the stand accessory.
DO ensure that all connections,
(including the mains plug, extension
leads and inter-connections between the
pieces of equipment), are properly made
pieces of equipment), are properly made
and in accordance with the
manufacturers instructions. Switch off
and withdraw the mains plug before
making or changing connections.
DO NOT listen to headphones at high
volume, as such use can permanently
volume, as such use can permanently
damage your hearing.
SHOULD you require to replace the fuse in
the moulded plug with a new fuse, then
please replace with one of the same value,
type and approval as the original. Ensure the
fuse cover is returned to its original position.
TO prevent scratching or damaging the
plasma screen face, do not knock or rub the
surface with sharp or hard objects. Clean the
screen with a soft cloth moistened with warm
water and dry with a soft cloth. A mild soap
may be used if the screen is extremely dirty. Do
not use harsh or abrasive cleaners!
IF you intend placing this TV into a cabinet or
a wall alcove, please ensure there is at least
a 100mm (10cm) gap to the sides, rear and
top of the TV. This is to allow for adequate
ventilation during your TV's operation.
DO read the operating instructions before
you attempt to use the equipment.
DO observe the manufacturers instructions
when connecting extension leads to your TV.
The fuse should be a 5 Amp fuse with the
safety symbols and displayed. If
you are in any doubt about the extension
installation, please consult a competent
electrician.
X832136-02-02.qxd 11/19/01 10:44 AM Page 4