Microtek gnc m vx2 0506 Manual Do Utilizador

Turn on the projector and any video players in the following sequence:

1.

Video Signal Source equipment

2.

Audio Signal Source equipment (If it is different from a computer or video

signal source)

3.

Projector

4.

External Speaker

5.

Computer

Remove the lens cover before the projector is turned on. When the power source

is connected, the Power Led Indicator will first blink for a few seconds and will be

fully lit when the connection of the power source is completed. If the computer and

the Video Signal Source are connected, an image depicting a computer or a Video

Signal Source will be displayed. It will take at least 30 seconds to display a

regular image after the power has been connected.

When the lamp is turned on, never let yourself or let children look into the lens of

the projector. The bright light emitted from the lamp into the lens of the projector

will seriously damage the eyes.

Remove the lens cover before the projector is turned on as the strong light

emitted from the lamp will damage the lens cover permanently.

To turn the projector and its accessory equipment off, please operate the above

steps in reverse order.

When the power source is disconnected, the built-in fan will continue to operate in

order to cool down the projector, and the Power Led indicator will turn orange and

blink for two minutes. When the projector has cooled down, Power Led indicator

will remain lit in green. If the projector is turned on while the Power Led indicator

is blinking in orange, the projector will not be able to display images.

Due to the design of the projector, the projector will not turn on immediately when

the Projection Lamp Led Indicator turns green and blinks. Please wait for a

moment until the lamp is ready.

ＶＸ２．ｐ６５

02-10-18, 11:05

23