culligan water tower Manual Do Utilizador

12

21. Install cartridges. (Refer to Figure 5 for location of  each cartridge).

a. Hold cartridge by its protective plastic bag.
b. Insert cartridge into manifold turning it 1/2 turn as it enters port. Slide bag from

cartridge and discard.

c. Install filter housing (Item 30) as each cartridge is inserted. Make sure housing

o-ring is properly lubricated.

Note: Tighten filter housings by hand only. Do not use tools as they will over-tighten and
damage housings. Take care not to cut or pinch the O-rings.

22. Turn feed water valve slowly to open position.

23. Confirm system is producing water. Unit will be sending rinse water to drain. Check

for leaks.

Note: Monitor must be re-set each time the system is serviced to ensure accurate
monitor performance.

TO RE-SET MONITOR or TO CHANGE BATTERY: Perform Steps 24-27
Refer to Figure 6 for component location.

Use caution when working inside enclosure. Wiring therein connects monitor components. If
wires, circuit board, or connections are damaged and/or wetted, monitor will not function.

Connect battery to monitor after system has been in production mode for at least 5 minutes.
This ensures sensing switch is in proper position to record data.

24. Disconnect battery. The connection is a snap type connector.

25. Remove battery by sliding it out of  its holder.