ONKYO CR-N1 Manual Do Utilizador
4
Precautions
1. Recording Copyright
Recording of copyrighted material for other
than personal use is illegal without permis-
sion of the copyright holder.
Recording of copyrighted material for other
than personal use is illegal without permis-
sion of the copyright holder.
2. AC Fuse
The fuse is located inside the chassis and is
not user-serviceable. If power does not come
on, contact your Onkyo authorized service
station.
The fuse is located inside the chassis and is
not user-serviceable. If power does not come
on, contact your Onkyo authorized service
station.
3. Care
From time to time you should wipe the front
and rear panels and the cabinet with a soft
cloth. For heavier dirt, dampen a soft cloth in
a weak solution of mild detergent and
water, wring it out dry, and wipe off the dirt.
Following this, dry immediately with a clean
cloth. Do not use rough material, thinners,
alcohol or other chemical solvents or cloths
since these could damage the finish or
remove the panel lettering.
From time to time you should wipe the front
and rear panels and the cabinet with a soft
cloth. For heavier dirt, dampen a soft cloth in
a weak solution of mild detergent and
water, wring it out dry, and wipe off the dirt.
Following this, dry immediately with a clean
cloth. Do not use rough material, thinners,
alcohol or other chemical solvents or cloths
since these could damage the finish or
remove the panel lettering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE
FIRST TIME, READ THE FOLLOWING SECTION
CAREFULLY.
The voltage of the available power supply
differs according to country or region. Be
sure that the power supply voltage of the
area where this unit will be used meets the
required voltage (e.g., AC 230 V, 50 Hz or AC
120 V, 60 Hz) written on the rear panel.
FIRST TIME, READ THE FOLLOWING SECTION
CAREFULLY.
The voltage of the available power supply
differs according to country or region. Be
sure that the power supply voltage of the
area where this unit will be used meets the
required voltage (e.g., AC 230 V, 50 Hz or AC
120 V, 60 Hz) written on the rear panel.
Setting the STANDBY button to standby does
not shut off the power completely. So the
power cord should be removed from the AC
outlet when the unit is not used for a pro-
longed time.
not shut off the power completely. So the
power cord should be removed from the AC
outlet when the unit is not used for a pro-
longed time.
5. Do not touch this unit with wet hands
Do not handle this unit or power cord when
your hands are wet or damp. If water or any
other liquid enters the case, take this unit to
an authorized service center for inspection.
Do not handle this unit or power cord when
your hands are wet or damp. If water or any
other liquid enters the case, take this unit to
an authorized service center for inspection.
6. Location of this unit
Place this unit in a well-ventilated location.
Place this unit in a well-ventilated location.
Take special care to provide plenty of ventila-
tion on all sides of this unit especially when it
is placed in an audio rack. If ventilation is
blocked, this unit may overheat and mal-
function.
tion on all sides of this unit especially when it
is placed in an audio rack. If ventilation is
blocked, this unit may overheat and mal-
function.
Do not expose this unit to direct sunlight or
heating units as this unit’s internal tempera-
ture may rise and shorten the life of the
pickup.
heating units as this unit’s internal tempera-
ture may rise and shorten the life of the
pickup.
Avoid damp and dusty places and places
directly affected by vibrations from the
speakers. In particular, avoid placing the
unit on or above one of the speakers.
directly affected by vibrations from the
speakers. In particular, avoid placing the
unit on or above one of the speakers.
Be sure this unit is placed in a horizontal
position.
position.
Never place it on its side or on a slanted sur-
face as it may malfunction.
face as it may malfunction.
Do not place near tuners or TV sets.
If placed next to a TV or tuner, it may cause
reception interference resulting in some
noise in the TV or tuner output.
reception interference resulting in some
noise in the TV or tuner output.
7. Points to remember
If this unit is brought from a cold environ-
ment to a warm one or is in a cold room that
is quickly heated, condensation may form on
the pickup, preventing proper operation. In
this case, remove the disc and leave the
power ON for about one hour to remove the
condensation.
If this unit is brought from a cold environ-
ment to a warm one or is in a cold room that
is quickly heated, condensation may form on
the pickup, preventing proper operation. In
this case, remove the disc and leave the
power ON for about one hour to remove the
condensation.
When transporting this unit, be careful not
to bump it.
to bump it.