ONKYO TX-DS787 Manual Do Utilizador

53

To change the listening mode during playback, turn the SSC dial
on the front panel or the listening mode buttons on the remote
controller (see page 59).

To listen with headphones, plug a pair headphones with a standard
stereo plug into the PHONES jack on the TX-DS787 front panel.

When you connect headphones, the unit will enter STEREO mode
automatically and no sound will be heard from the speakers. Note
that the signal to the remote zone (Zone 2) will not be affected
whether or not headphones are connected.

Though the TX-DS787 is often used to listen to the radio, it does
not show you its true ability until it is used to play music or watch
videos, LDs, DVDs, and the like. The TX-DS787 has the latest in
state-of-the-art features to play back today’s acoustic technologies
with the utmost in fidelity and power. From a two-speaker system
to a seven-speaker system, you are assured a sound space that you
can always enjoy.

Before you can listen to any input media, you must first select the
input source at the TX-DS787. This tell it which input source to
output to the speakers and monitor.

To select an input source, simply press the button on the front
panel (or on the remote controller) that corresponds to the input
source you want.

After you have selected the input source, simply turn on the
corresponding component and play the media.

Adjusting the main volume adjust the volume level output from all
the speakers connected to the TX-DS787 together. If headphones
are connected, this also adjusts the volume heard from the
headphone speakers. To adjust the volume, either press the VOL

 buttons on the remote controller or turn the MASTER

VOLUME dial. To increase the volume, turn the dial to the right;
to decrease the volume, turn the dial to the left.