Hitachi 42pd7500a Manual Do Utilizador

Mounting the Speaker Unit

INSTALLATION INSTRUCTIONS (continued)

Make sure that the main power switch of the monitor is turned off (standby mode or the indicating lamp: off/red) when removing or connecting
the speaker cables.

CAUTION

Make sure to use the speaker systems fastened with the speaker
holders and the screws.

CAUTION

Mounting the Speaker System to the Monitor

1. Mounting the Speaker System to the Monitor.

Hook the clamps (3 pieces) into the holes as shown in the figure,
and pull them down.
Follow the step for both Left and Right sides.

2. Attach the speaker holders.

After twisting the screws off as shown, fasten the speaker system to the monitor with the speaker holder by the screws.
The speaker holder direction is opposite on the Right and Left speaker systems.

3. Attach the speaker connecting cables to the monitor. (Make sure the ferrite core is toward the monitor side.)

Right Side

Rear of the monitor

Clamps

Right Side

Rear of the monitor

Twist off
the screws

Speaker holder

Monitor

Speaker
System

Speaker holder

Screws x 4

Aluminum trims

Screwdriver

NOTE

In the event of the
speakers not
aligning correctly
with the panel.

Loosen the screws
holding the aluminum
trims and adjust up or
down to fit.

Pull off whilst twisting

Please prepare the supplied
speaker cables

Treating the wire ends

Press down
the lever

Raise
the lever

Insert the wire

How to connect
the speaker
cables
(Monitor side)

Place to attach the side input.

Ferrite core

(R)

Red

Black

(L)

Red

Black

Connect the
copper
colored wire

Connect the
silver
colored wire

Connect the
copper
colored wire