ONKYO DX-7333 Manual Do Utilizador
5
Before operating this unit
1. Remove the battery compartment cover by opening it as shown in
the illustration.
2. Insert two AA (R6- or UM-3)-size batteries into the battery compart-
ment. Carefully follow the polarity diagram (positive (+) and nega-
tive (–) symbols) inside the battery compartment.
tive (–) symbols) inside the battery compartment.
3. After batteries are installed and seated correctly, replace the com-
partment cover.
Notes
•
Do not mix new batteries with old batteries or different kinds of
batteries.
batteries.
•
To avoid corrosion, remove the batteries if the remote controller
is not to be used for a long time.
is not to be used for a long time.
•
Remove dead batteries immediately to avoid damage from cor-
rosion. If the remote controller doesn’t operate smoothly,
replace both the batteries at the same time.
rosion. If the remote controller doesn’t operate smoothly,
replace both the batteries at the same time.
•
The life of the batteries supplied is about six months but this
will vary depending on usage.
will vary depending on usage.
Point the remote controller toward the remote control sensor.
Notes
•
Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation of the
remote controller.
inverted fluorescent light which can prevent proper operation of the
remote controller.
•
Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operational interference.
room or using the unit near equipment which uses infrared rays
may cause operational interference.
•
Do not put any object such as a book on the remote controller.
The buttons of the remote controller may be pressed by mistake
and drain the batteries.
The buttons of the remote controller may be pressed by mistake
and drain the batteries.
•
Make sure the audio rack doors do not have colored glass. Plac-
ing the unit behind such doors may prevent proper remote con-
troller operation.
ing the unit behind such doors may prevent proper remote con-
troller operation.
•
If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
remote control sensor, the remote controller will not operate.
Installing the remote controller batteries
Using the remote controller
3
2
1
Remote
control sensor
control sensor
30˚
30˚
DX-7333
approx. 5 m
(16 feet)
REM
OTE
CO
NT
RO
LLE
R
R
C-4
02C
PEA
K SE
ARC
H
+10
0
TIM
E ED
IT
CLE
AR
ME
MO
RY
REP
EAT
DIS
PLA
Y
7
8
4
5
1
2
9
6
3
NEX
T
SEL
ECT
ION
A–B
SHU
FFL
E
DX-7333(E)Book Page 5 2001年 4月 26日 木曜日 10:28 AM