Velleman CAMCOLD13 Manual Do Utilizador

 

04/03/2009

 

©2008 Velleman

®

 Components nv

 

3

This symbol on the device or the package indicates that disposal of the device 
after its lifecycle could harm the environment. 
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should 
be taken to a specialized company for recycling. 
This device should be returned to your distributor or to a local recycling service. 
Respect the local environmental rules. 

If in doubt, contact your local waste disposal authorities. 
Thank you for choosing the Velleman!  Please read the manual thoroughly before bringing this 
device into service. If the device was damaged in transit, don't install or use it and contact 
your dealer. 
2. 

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual. 
•  Protect this device from shocks and abuse. Avoid brute force when operating the device. 

•  Protect the device against extreme heat and dust. 

•  Familiarise yourself with the functions of the device before actually using it.  

•  All modifications of the device are forbidden for safety reasons. 

•  Only use the device for its intended purpose. Using the device in an unauthorised way will 

void the warranty. 

•  Damage caused by disregard of certain guidelines in this manual is not covered by the 

warranty and the dealer will not accept responsibility for any ensuing defects or problems. 

•  A qualified technician should install and service this device. 

•  Note that damage caused by user modifications to the device is not covered by the 

warranty. 

•  DO NOT use this product to violate privacy laws or perform other illegal activities. 
3. 

•  excellent performance under low lux 

•  vandal-proof housing design 

•  automatic controlled iris lens 

•  very high resolution camera 
4. 

•  Open the dome camera by holding the base and turn the plastic dome counter clockwise. 

•  Remove the protective cap by releasing both screws [C] (on opposite sides).  

•  Mount the dome camera in the desired location. Use the base as a template for the 

mounting holes. 

•  Point the camera towards the field of interest. 

•  Release screw [A] until the housing can be moved and set the desired zoom factor.  

•  Tighten screw [A] hand tight. Do not force to avoid damage to the mechanism. 

•  Release screw [B] until the housing can be moved and set the desired focus.  

•  Tighten screw [B] hand tight. Do not force to avoid damage to the mechanism. 

•  Place the protective cap back and secure both screws [C]. 

•  Screw the plastic dome back in place (clockwise).