Intex Recreation 634 Manual Do Utilizador

(110)  MODEL 634 FILTER PUMP  ENGLISH  7.5” X 10.5” PANTONE 295U  01/31/2007

6.

Remove the "OLD" filter cartridge.

7.

Examine the inside of the filter housing.

8.

If dirt or sediment is located on the bottom of the housing then:
A. In a counter-clockwise motion gently unscrew and remove the sediment 

valve (2) located at the bottom of the housing. Place it in a safe place.

B. With a bucket of water or a garden hose pour water into the housing 

flushing out the sediment.

C. In a gentle clockwise motion return the sediment valve (2) to its location.

Do not over-tighten.

9.

Place a new cartridge filter in the housing.

10. Return the housing cover (4) to its position and in a clockwise direction rescrew

the housing collar (1) onto the filter housing.

11. Turn both plunger valve handles in a counter-clockwise direction, pull up until 

they stop, and then turn them clockwise until the metal protruding notch 
anchors in the "0/1" position.

12. When the trapped air has escaped through the air release valve gently 

retighten the valve (2) in a clockwise direction.

13. Reconnect the power cord.
14. Turn the pump "ON".

Some countries, especially in the European community, require the filter-pump to
be secured to the ground or to a base in a permanent upright position. Check your
local authorities to determine if there is a regulation in your area regarding 
above-the-ground swimming pool filter-pumps. If yes, then the filter-pump can be
mounted to a platform using the two holes located in the base. See drawing below.

The filter-pump can be mounted on a cement base or onto a wooden platform to
prevent accidental falling over. Total assembly must exceed 18kg. The European
norm EN 60335-2-41 requires this product be secured to the ground or to a base.

1.

The mounting holes are 6.4 mm in diameter and spaced 165 mm apart.

2.

Use two bolts and lock nuts with a maximum of 6.4 mm in diameter.