GE 175d1807p239 Manual Do Utilizador

Washer is unplugged

Make sure cord is plugged securely into a working outlet.

Water supply is turned off

Turn both hot and cold faucets fully on.

Controls are not set

Check controls and make sure Cycle knob is pulled out 

properly

to ON position.

Lid is open

Close lid and pull Cycle knob out to ON position.

Circuit breaker/fuse is

Check house circuit breakers/fuses. Replace fuses or 

tripped/blown

reset breaker. Washer should have separate outlet.

Control is not set properly

Check water temperature control and adjust.

Water supply is turned off

Turn both hot and cold faucets fully on and make sure 

or improperly connected

hoses are connected to correct faucets.

Water valve screens are

Turn off the water source and remove the water 

stopped up

connection hoses from the upper back of the washer.

Use a brush or toothpick to clean the screens in the

machine. Reconnect the hoses and turn the water 

back on.

House water heater is

Make sure house water heater is delivering water 

not set properly 

at 120°F.–140°F.(48°C.–60°C.).

Drain hose is kinked or

Straighten drain hose and make sure washer is not

improperly connected

sitting on it.

Top of drain outlet should be less than 8 ft. above floor.

Fill hoses or drain hose is

Make sure hose connections are tight at faucets and 

improperly connected

make sure end of drain hose is correctly inserted in 

and secured to drain facility.

Household drain may

Check household plumbing. You may need 

be clogged

to call a plumber.

Constant water pressure

Tighten hoses at the faucets and turn the water off 

to the fill hoses at the

after each use.

water source

Check condition of the fill hoses; they may need

replacement after 5 years.

Washer is uneven

Make sure washer is level and firm to the floor.

Washer load is

Push the Cycle knob in to stop the washer, open the 

unbalanced

lid and redistribute the load evenly. Close the lid 

and restart.

The washer normally pauses
between washing steps

Incorrect cycle selected

Make sure the cycle selected matches the load 

you are washing.

8

Troubleshooting Tips 
Save time and money! Review the charts on the following
pages first and you may not need to call for service.