Hitachi 42pma400e Manual Do Utilizador

Size Switching

Each time the SIZE button of the remote control or the
monitor is pressed, the screen display size (or display
area) will change in sequence and the status will be
displayed at the bottom of the screen.

• During RGB signal input

• Some types of signals may not be able to switch as desired.
* VGA and W-VGA only

• During VIDEO signal input

(when the optional video unit is attached)

• Depending on the type of signal, in some cases it may not be

possible to switch the size, or switching to some sizes may not be
possible.

FULL

NORMAL FULL ZOOM1

REAL ZOOM3 ZOOM2

4:3 PANORAMA MOVIE1

FULL MOVIE2

Displaying Two Screens

If the PinP button on the remote control is pressed when
the optional video unit is installed, two screens will
display.

Activating the P-in-P mode from the RGB input screen

Pressing the PinP button one time will display two
screens.

･ The speaker icon can be shifted left and right by pressing the

and

SELECT buttons; the audio

of the video will be output from the
side on which the speaker icon is
located.

･ The sub-screen can be selected

with the VIDEO1 and VIDEO2
buttons from the status shown in the
diagram to the right.

･ Pressing the PinP button again will

cancel the two screen display.

V1: Displays the VIDEO input signal of the sub-screen.

Activating the P-in-P mode from the video input screen

Pressing the PinP button one time will display two
screens.

• The speaker icon can be shifted

left and right by pressing the

and

SELECT buttons; the audio of

the video will be output from the
side on which the speaker icon is
located.

• Pressing the PinP button again will

increase the size of the screen.

• Pressing the PinP button once

again will cancel the two screen
display.

• When VIDEO1 set it to RGB Video, it is not completed in P in P mode.

Refer to two screen table

PinP button

SIZE button

AUTO

PinP

SIZE

MUTE

VOL

RECALL

RGB 1

RGB 2

ENTER

VIDEO 1

VIDEO 2

RETURN

ID SET

SIZE button

RECALL button

Input Signal Screen Display

RGB1
[RGB]

H : 46.5kHz V : 60Hz

Input terminal name

The input signal status can be displayed on the screen
by pressing the RECALL button of the remote control.

･ The display will go out in approximately 3 seconds.

Input horizontal
frequency

Input vertical
frequency

VIDEO2
[COMPONENT]

VIDEO

RGB

(Sub-
screen)

OPERATING INSTRUCTIONS (continued)

TIPS

･ Even if the input of the horizontal / vertical synchronizing signal

(or video signal) stops in the two screen display, the mode will
not change to power save mode.

･ Please be careful since image retention will occur if display is left

in a two screen display state for a long period of time.

RECALL button