Hitachi 32ld380ta Manual Do Utilizador
11
ENGLISH
30
30
Z
Z
Z
Z
Z
Z
Install the batteries
Use batteries type UM-4 (AAA-Size).
Do not use the storage batteries. The remote control does not work properly with weak voltage from the storage
batteries. Replace the exhausted batteries with new batteries. Never charge batteries. Batteries may explode by
the charge.
Do not use the storage batteries. The remote control does not work properly with weak voltage from the storage
batteries. Replace the exhausted batteries with new batteries. Never charge batteries. Batteries may explode by
the charge.
Note:
An exhausted empty batteries may leak, namely corrosive electrolyte will leak out. The remote control may
damage by it. Therefore remove the exhausted batteries early.
damage by it. Therefore remove the exhausted batteries early.
3
1
Open the battery compart-
ment.
ment.
Close the battery
compartment.
compartment.
2
Install the batteries as shown
below.
below.
The remote control handset will not work properly in the following cases:
If bright sunlight directly beams onto the unit front.
If an obstacle is placed between the unit and the
handset.
handset.
If the batteries have not been installed according
to their polarities.
to their polarities.
If the batteries are weak.
Distance of Remote Control Operation
Point the remote control
directly at the remote sensor.
Transmitter window
Maximum distance approx. 5m
Remote Control
Remote sensor
3V90441A [E] P09-12
31/10/05, 9:21 AM
11
32LD380TA
HITACHI