Hitachi gf-2000 Manual Do Utilizador
Troubleshooting: Hitachi GF-2000 4.7G DVD-RAM User's Guide
Problem
Possible Causes
Corrective Action
Cannot play a DVD or CD in the drive
or certain types of discs cannot be
read in the drive.
1. The disc is placed upside down
in the disc tray.
2. The disc is dirty.
3. The pick-up lens is dirty.
4. The disc is scratched or warped.
5. The disc has a region code that
cannot be played on the drive.
1. Place the disc right side up.
2. Clean the disc surface.
3. Clean the pick-up lens.
4. Change the disc.
5. Refer to your system manual for
help.
Disc Tray cannot be opened
1. Power is not turned on.
2. The lock function has been
activated.
3. The tray is stuck.
1. Turn the power on and try again.
2. De-activate the lock function.
Turn off the DVD-RAM drive.
Insert a straightened paperclip
into the manual emergency eject
hole. Pull the disc tray open.
Drive is not recognized by system.
1. The cables are not properly
connected.
1. Turn off your system, make sure
your cables are seated properly
and re-install the device driver.
Cannot write to DVD-RAM media
1 . A 2.6 G bare media DVD-RAM
disc is installed in the DVD-
RAM drive.
2. Write Protect Switch on the
DVD-RAM media cartridge is
set to "PROTECT".
3. DVD-RAM media was removed
from the cartridge and returned
to the cartridge upside down.
1 . Most 2.6 G media was
produced without a special
code on it that tells the drive it
is well protected enough to be
written without being in a
cartridge. Insert the bare 2.6 G
disc into a cartridge, close the
cartridge and insert the
cartridge for writing. To insert
the disc in the cartridge, align
the label side of the disc with
the DVD-RAM cartridge label
side. Then insert the disc in
and close the cartridge lid.
2. With a ballpoint pen, slide the
Write Protect Switch toward the
edge of the cartridge away from
the "PROTECT" position.
3. Remove the DVD-RAM media
from the cartridge, flip it and
return it to the cartridge. To
return the disc to the cartridge,
align the label side of the disc
with the DVD-RAM cartridge
label side. Then insert the disc
in and close the cartridge lid.