ONKYO CDR-201A Manual Do Utilizador

31

Pressing the YES button provides the same
operation.
The level sync function turns off. Press the EDIT/
NO button to return to the previous setting.

Note:
This setting cannot be made during recording.

Pressing the YES button provides the same
operation.
The current setting appears. The current setting
is given on the left side (for the display given
below, the current setting is "On").

During analog recording, the track numbers are
assigned automatically since the level sync function is
turned on. Even so, you can press the o REC (or the
remote controller o REC button) to assign the track
numbers manually. To disable the automatic
assignment of track numbers during recording, turn
off the level sync function.
Turn off the level sync function and assign the track
numbers manually, if the numbers are not
automatically updated due to the situations as
follows:

For analog recording
The level sync function uses the recording source
level to detect the end and beginning of tracks.
Therefore, in the cases given below, the track
numbers may not be properly assigned.

• The recording on the cassette tape is poor (e.g.,

the space between songs contains much noise).

• With music such as classical music where there

may be very low volumes.

• Where the space between songs is extremely

short.

• If the signal at the tuner is weak (excessive

noise).

• When recording from turntables.
• When the level sync function is turned on, if no

signal continues for approximately one minute,
recording will stop.

• When digitally recording satellite broadcasts, the

track numbers may not be assigned properly. If
this occurs, turn off the level sync function and
set the track numbers manually.

• If the time between tracks is extremely short, the

track numbers may not be assigned properly.

• When the level sync function is turned on, if no

signal continues for approximately one minute,
recording will stop. However, you can continue
recording to CDs.

Switch the setting to ON.
Follow the steps 1 through 3. "Off 

→ On" should

appear in step 2, "L.Sync On" in step 3.

MULTI JOG

PUSH TO ENTER

MULTI JOG

PUSH TO ENTER

EDIT / NO

PUSH TO ENTER

MULTI JOG