Hunter Fan 28448 Manual Do Utilizador

41716-01  06/17/2004

2

© 2004 Hunter Fan Company

Lower Switch Housing
Before you can install the light fixture, you must

remove the wiring harness and its components

from the lower switch housing.  You must then

install the wiring harness into the light fixture.
Refer to Figure 2.
1. Locate the reversing switch and carefully

remove the two screws holding the reversing

switch to the lower switch housing.  The

reversing switch can now be removed from

the lower switch housing.

2. Remove the patented breakaway connector

from the fan pull chain.

3. Carefully loosen the bellmouth nut from the

fan pull chain and remove the fan pull chain

switch from the lower switch housing.

4. Locate and carefully remove the two capacitors

from the lowerswitch housing.

5. You have now disconnected the wiring harness

and its components from the lower switch

housing and are ready to install them into the

light fixture.

Fixture
Refer to Figure 3.
1. Insert the pull chain and fan pull chain switch

through the round opening on the side of the

switch housing.  Thread the bellmouth nut over

the pull chain and hand tighten the bellmouth

nut.

2. Reattach the patented breakaway connector

to the end of the pull chain.

3. Insert the reversing switch into the square hole

on the side of the switch housing.  Install and

tighten the two screws you removed previously

from the other switch housing.

4. Carefully place the capacitors in the switch

housing.

Installing the Light Fixture
1. Using the wire nuts currently on the single

black wire and single white wire, Connect the

black wire from the light fixture to the black/

white wire from the wiring harness and connect

the white wire from the light fixture to the

white wire from the wiring harness.

2. Reconnect the upper plug connector from the

upper switch housing to the lower plug

connector in the light fixture.
Note:  Both plug connectors are polarized and

will only fit together one way.  Make sure that

both connectors are properly aligned before

connecting them together.  Incorrect

connection could cause improper operation and

damage to the product.

3. Align the holes in the upper switch housing

and the light fixture.  Securely tighten the three

switch housing assembly screws.

Figure 2 - Removing the wiring harness from the lower

switch housing

Figure 3 - Installing the wiring harness into the light fixture

Bellmouth Nut

Fan Speed

Switch

Capacitor

Housing

Assembly

Screws

Reverse Switch

Multi-wire

Plug

Connector

Capacitor

Bellmouth Nut

Fan Speed

Switch

Capacitor

Housing

Assembly

Screws

Reverse Switch

Multi-wire

Plug

Connector

Capacitor

Light Switch