Oregon bar908hg Manual Do Utilizador

EN

11

next to the Area. Then, simultaneously press and hold MEM 
and CHANNEL for 2 seconds.
NOTE

  If  the  sensor  is  still  not  found,  check  the 

batteries.

This  product  tracks  the  time  and  date  based  on  radio-
controlled  signals  from  the  RTGN318  /  RTGN318D  / 
RTGN318A  remote  sensor,  or  manual  settings  that  you 
enter.

The  time  and  date  are  automatically  updated  by  radio-
controlled  clock  signals  from  official  time-keeping 
organizations.  The  signals  are  collected  by  the  remote 
sensor RTGN318 / RTGN318D / RTGN318A.
•  BAR908HG (RTGN318):
DCF-77  signal:  within  1500  km  (932  miles)  of  Frankfurt, 
Germany.
•  BAR908HGU (RTGN318D):
Slide EU / UK to select the signal received.
EU: DCF-77 signal: within 1500 km (932 miles) of Frankfurt, 
Germany.
UK: MSF-60 signal: within 1500 km (932 miles) of Anthorn, 
England.
•  BAR908HGA (RTGN318A):
WWVB-60  signal:  within  3200  km  (2000  miles)  of  Fort      
Collins,Colorado.
Initial  reception  takes  2-10  minutes,  and  is  initiated  when 
you first set up the unit, and whenever you press RESET. 

Once complete, the reception icon will stop blinking.

The 

  icon  shown  in  the  Clock  Area  indicates   

2 factors:

•  Connection  between  the  main  unit  and  the  sensor   

that collects RF signals (   )

•  RF signal reception ( 

 )

The unit has contact 
with the sensor and 
has synchronized the 
time.

The unit has contact 
with the sensor but 
the time has not been 
synchronized.

The unit has lost 
contact with the remote 
sensor but the time is 
synchronized.

The unit has lost 
contact with the remote 
sensor and the time is 
not synchronized.

The unit cannot reach 
the remote sensor.