Microboards Technology gx-1 Manual Do Utilizador
•
16
Utility Tab
The Resolution setting should always be
set at .1mm for best results.
set at .1mm for best results.
Alignment values will move the print
image on the disc.
image on the disc.
The Outer and Inner Diameters will
change the size of the area to be printed.
To avoid excessive ink buildup, these
values should never be set so that the GX-
1 Disc Publisher is printing off the media.
change the size of the area to be printed.
To avoid excessive ink buildup, these
values should never be set so that the GX-
1 Disc Publisher is printing off the media.
If you have media with a printable inner
hub separated from the rest of the disc by
an unprintable ring, you can set the inner
and outer hub diameters appropriately. If
you are using media with a continuous
print surface, the Print on Hub setting
should not be checked.
hub separated from the rest of the disc by
an unprintable ring, you can set the inner
and outer hub diameters appropriately. If
you are using media with a continuous
print surface, the Print on Hub setting
should not be checked.
Ink Level
The Ink Levels show how much remains of all 3 colors, Cyan, Magenta and Yellow.
NOTE: If you place a used cartridge in the GX-1, the ink level may not be reported correctly. If the
GX-1 can identify the cartridge, it may report the correct ink levels; if not, it will assume that the ink
cartridge is new and will show ink levels of 100%.
GX-1 can identify the cartridge, it may report the correct ink levels; if not, it will assume that the ink
cartridge is new and will show ink levels of 100%.
Before each disc is printed, the ink levels are checked. If the level of any one color is has reached
10%, a warning message will be displayed on your PC and printing will be temporarily suspended.
You can either change the cartridge at this point and click OK, or click OK to continue printing using
the same cartridge.
10%, a warning message will be displayed on your PC and printing will be temporarily suspended.
You can either change the cartridge at this point and click OK, or click OK to continue printing using
the same cartridge.
If you continue with the same cartridge, printing will continue uninterrupted until the ink level reaches
5%. The low ink level warning will be displayed once more. Again, either change the cartridge or
continue.
5%. The low ink level warning will be displayed once more. Again, either change the cartridge or
continue.
Once the ink level reaches 3% or less, the warning will be displayed before each print.
It is strongly recommended that you replace the cartridge at this point.