RoyalTek rtg-2000 Manual Do Utilizador

English

Before you use RTG-2000, the battery must be charged for at least six

hours. Plug car charger into power jack and cigar-lighter separately. As

RTG-2000 is in charging, the Yellow LED will be lighted up. When the

battery is fully charged, the Yellow LED will be turned off. Unplug car

charger from power jack and cigar-lighter separately.

STEP 2: Turn on Receiver and wait for GPS fix

If the position has not been fixed yet, the Green LED will be blinking.

STEP 3: Connect to Bluetooth-enabled handheld device

From your Bluetooth-enabled handheld device, execute Bluetooth

application software to search RTG-2000 and then connect it to your device.

If the connection between your device and RTG-2000 is not successful, the

Blue LED will be blinking.

New→Connect

STEP 4: Connect to your Navigation Software

Install and launch your navigation software in Navigation Software Kit and

set GPS configuration. Select correct COM port subject to the outbound

Bluetooth serial port of your handheld device and correct baud rate

depending on your navigation software.

•If you are required to type in pin code during configuration, please key in

Explore a Bluetooth
device

Tap Bluetooth GPS
BlueGPSxxxxxx

Select Serial Port

Successful

Tap BlueGPS→
Connect

Click Finish