Hatco gr2sdm-0102 Manual Do Utilizador
12
Form No. GR2SDM-0102
ACCESSORIES
TEMP.
F
SP1
SP1
Mode Switch
Setpoint Screw
Figure 6. Optional LED Temperature Control.
Figure 7. Optional 4" (10 cm) Designer Legs.
LED TEMPERATURE CONTROL
Models GR2SDH and GR2SDS may be equipped with
an LED temperature control device which regulates the
base temperature and also indicates the current
base temperature.
an LED temperature control device which regulates the
base temperature and also indicates the current
base temperature.
NOTE: This option is factory installed only, not
available for retrofit.
available for retrofit.
NOTE: Units with the LED temperature control do not
have an additional separate base thermostat. All
temperature regulation is performed by the controller.
have an additional separate base thermostat. All
temperature regulation is performed by the controller.
NOTE: Units with LED temperature controls
manufactured for use outside the United States use
devices that indicate temperature in Celsius (°C).
manufactured for use outside the United States use
devices that indicate temperature in Celsius (°C).
The programming instructions are as follows:
1. To set the temperature, turn the red Mode Switch
counterclockwise to the SP-1 position indicated on
the controller. See Figure 6.
the controller. See Figure 6.
2. Adjust the Setpoint Screw to the desired
temperature, then turn the red Mode Switch to the
TEMP position. The surface temperature range is
room temperature to 200° F (93° C).
TEMP position. The surface temperature range is
room temperature to 200° F (93° C).
4" (10 cm) DESIGNER LEGS
1. Installation of the 4" (10 cm) Designer Legs is
accomplished by placing the unit on its non-control
side.
side.
2. Place hexbolt through short foot (with bolt head on
recessed foot side) and through Designer Leg. Align
bolt in corner hole on base and tighten securely.
See Figure 7.
bolt in corner hole on base and tighten securely.
See Figure 7.
3. After all the legs are secure, return the unit to its
upright position.
STAINLESS STEEL DIVIDER RODS
Additional stainless steel divider rods help to keep
product separate in the channels.
product separate in the channels.
DESIGNER INSET COLOR PANELS
Choose from warm red, black, gray granite, white
granite, hunter green and navy blue inset panels to
coordinate warmer to your decór.
granite, hunter green and navy blue inset panels to
coordinate warmer to your decór.
BREATH PROTECTOR(S)
(NOT FOR RETROFIT)
Units can be supplied from the factory with breath
protector(s) on the customer side. To install follow these
steps.
Units can be supplied from the factory with breath
protector(s) on the customer side. To install follow these
steps.
1. Remove protective paper from acrylic surfaces.
2. Position the acrylic breath protector into the channel
on the warmer with the mounting holes aligned.
3. Secure the breath protector using the thumbscrews
and acorn nuts provided. Tighten thumbscrew until
snug. Do not overtighten.
snug. Do not overtighten.
CAUTION
Only soft cleaning cloths should be used to clean
breath protector(s). Breath protector(s) are made of
shatterproof polycarbonate and will scratch if proper
care is not taken.
breath protector(s). Breath protector(s) are made of
shatterproof polycarbonate and will scratch if proper
care is not taken.