Harley-Davidson bfr550 Manual Do Utilizador

16. Insert wiring through hole and route under handlebar

into the headlamp nacelle. Fasten V-logo to shroud
cover using two panhead screws. Tighten securely. 

17 With the halves of the headlamp nacelle parted slightly,

slide the handlebar clamp shroud onto the flange at the
top of the headlamp nacelle while positioning the flat
washer on the Phillips screw against the inside surface
of the nacelle. To secure the shroud to the nacelle,
tighten the Phillips screw to 10-20 in-lbs (1.1-2.3 Nm).

18. Install two Phillips screws to secure the handlebar

clamp shroud to the fork lock mechanism. Install the
fork lock plate.

19. Inserting the weld stud on the chrome strip into the hole

at the top of the headlamp nacelle, reach inside the
nacelle to install the speednut removed in Step 6.
Tighten to 10-20 in-lbs (1.1-2.3 Nm).

20. Install the wireform clip to secure the halves of the

nacelle together at the bottom.

21. Tighten the two acorn nuts on each side of the fork

studs to 18 ft-lbs (24.4 Nm).

22. See Figure 3. Locate the Turn Signal Multilock

Connector and unplug connector halves. Pull conduit
back to expose wires.

23. Following instructions in Service Manual under “Sealed

Butt Splice Connectors”, splice the wiring from the V-
logo to the left and right turn signal wires and to ground.
(Purple-to-Purple, Brown-to-Brown, Black-to-Black).
Mate the connector halves.

24. Install the wire connector at the back of the headlamp

bulb.

25. Align holes in headlamp housing with those in

headlamp nacelle (headlamp door bracket at bottom).
Install seven Phillips screws.

26. Fit the square-shaped portion of the headlamp door

spring into the slot at the top of the headlamp housing
and then snap the headlamp door (chrome ring) into
place. Install the Phillips screw at the bottom of the
headlamp door.

27. Following instructions in Service Manual, install the

windshield.

28. Connect battery cables.

-J01588