Kenwood TK-7160 Manual Do Utilizador
TK-7160
9
7. Ignition Sense Cable (KCT-18)
The KCT-18 is an optional cable for enabling the ignition
function. The ignition function lets you turn the power to the
transceiver on and off with the car ignition key.
transceiver on and off with the car ignition key.
7-2. Connecting the KCT-18 to the Transceiver
1. Install the KCT-39 in the transceiver. (See the KCT-39 sec-
tion)
2. Insert the KCT-18 lead terminal (
1
) into pin 2 of the KCT-
39 (
2
).
2
1
13
15
1
3
7-3. Modifying the Transceiver
Modify the transceiver as follows to turn the power on and
off with the ignition key.
1. Remove the jumper resistor (0
Ω) R95 of the TX-RX unit.
■ Setting With the KPG-99D
Select “Function port” from the “Edit” menu and enable
the “Ignition Sense”.
Fig. 7
Fig. 8
R95
CN2
TX-RX UNIT
Component side
Component side
REALIGNMENT / INSTALLATION
1. PA/HA Unit (KAP-2 : Option)
1-1. Installing the KAP-2 in the Transceiver
The Horn Alert and Public Address functions are enabled
by inserting the KAP-2 relay unit.
■ Installation Procedure
The accessories of KAP-2 use “KIT A” for this transceiver.
1. Open the case and shield cover of the transceiver.
2. Remove the jumper lead from CN6 connector on the TX-
2. Remove the jumper lead from CN6 connector on the TX-
RX unit.
3. Lift the DC cord bushing (
1
) from the chassis and re-
move the pad as shown in the Figure 1 (
2
).
1
2
Fig. 1
4. Affix the new pads (supplied with the KAP-2) to the DC
cord (
3
) and chassis (
4
).
3
4
G13-2083-04
(9 x 3.5 x 4 mm)
(9 x 3.5 x 4 mm)
G13-2084-04
(6 x 6 x 1.5 mm)
(6 x 6 x 1.5 mm)
Fig. 2