Hitachi 60UX58K Manual Do Utilizador

SET UP 

- 30 - 

Press EXIT to quit MENU or CURSOR 

 to return to previous menu. 

 

Reception channels for each mode are shown at the left. 
Refer to your cable or TV guide for channel identification standards. 
If certain CATV channels are poor or not possible in CATV1 mode, set SIGNAL SOURCE to CATV2. 

This feature will automatically store active TV channels in CHANNEL MEMORY. This will allow you to skip over 

unused channels when using CHANNEL UP (

) or DOWN (

) buttons. 

Auto Channel Set Menu  

If the EXIT button is pressed while the AUTO CHANNEL SET function is engaged, programming will stop. If two 
antennas are connected, switch antenna inputs with the INPUT button and repeat AUTO CHANNEL SET for the 
second antenna input. 
Remember to select the correct SIGNAL SOURCE mode before using AUTO CHANNEL SET for the second 
antenna input. 
See CHANNEL MEMORY to add or erase additional channels. 

Use this function after AUTO CHANNEL SET to add or erase additional channels to the remote control CHANNEL 

 or 

 buttons. 

Channel Memory Menu 

Add or erase additional channels while still in CHANNEL MEMORY using CURSOR 

 or 

 or the number 

buttons to change the channel. 

Press EXIT to quit menu or CURSOR 

 to return to previous menu. 

This function allows you to review which channels are labeled in CHANNEL ID (ID.) which have been added to 
CHANNEL MEMORY (SCAN), and which are protected by CHILD LOCK (LOCK). 

Channel List Menu  

Press CURSOR 

 or 

 to review more channels. 

Press EXIT to quit menu or CURSOR 

 to return to previous menu. 

NOTE: Each touch of CURSOR 

 or 

 will scan to the next eight channels.