omnitron-systems-technolo 10-100m Manual Do Utilizador
•
Multiplexer State - Indicates the Multiplexer state (“Discard”, “Forward” or “Unknown”) of the remote
ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs to the lower sublayer.
If “Discard”, the remote partner is discarding non-OAMPDUs network frames. If “Unknown”, the
Multiplexer state of the remote partner is indeterminate.
ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs to the lower sublayer.
If “Discard”, the remote partner is discarding non-OAMPDUs network frames. If “Unknown”, the
Multiplexer state of the remote partner is indeterminate.
•
Parser Action - Indicates the Parser Action state (“Discard”, “Forward” or “Loopback”) of the remote
ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs network frames to
the higher sublayer. If “Loopback” is displayed, the remote partner is looping back non-OAMPDUs
network frames. If “Discard” is displayed, the remote partner is discarding non-OAMPDUs network
frames.
ports. If “Forward” is displayed, the remote partner is forwarding non-OAMPDUs network frames to
the higher sublayer. If “Loopback” is displayed, the remote partner is looping back non-OAMPDUs
network frames. If “Discard” is displayed, the remote partner is discarding non-OAMPDUs network
frames.
•
Critical Event - Indicates the Critical Event state (“Yes” or “No”) of the remote partner. If “Yes” is
displayed, the local device has detected a Critical Event. If “No”, the local device has not detected a
critical event.
displayed, the local device has detected a Critical Event. If “No”, the local device has not detected a
critical event.
•
Link Fault - Indicates the remote partner has detected a fault in the receive direction (“Yes” or “No”). If
“Yes” is displayed, the receive link is down. If “No”, the receive link is up.
“Yes” is displayed, the receive link is down. If “No”, the receive link is up.
•
OAM Mode - Indicates the OAM mode (“Active” or “Passive”) of the remote partner.
•
Supports - Indicates the supported options (Variable Access “Var”, Link Event Notification “Event”,
Loopback “LB” or blank if no options are supported) of the remote partner.
Loopback “LB” or blank if no options are supported) of the remote partner.
•
OUI - Indicates the three hex byte IEEE organizational specific identifier (or blank if unknown) of the
remote partner.
remote partner.
802.3ah parameters can be accessed by selecting options 7 from the Port configuration screen. The fiber
configuration screen is displayed.
configuration screen is displayed.
802.3ah Control - iConverter 10/100M
iConverter, Serial Agent
Identifier -
Chassis Number = 1 Slot Number = 1 Model Number = 8919-0
Port # = 1
1: 802.3ah OAM State
Enabled
Local Status
2: OAM Mode
Active
Discovery State
Incomplete
3: Loopback Mode
Disabled
Multiplexer State
Forward
4: Loopback Timeout
30 sec
Parser Action
Forward
5: Unidirectional Mode
Not Available
Remote Status
Discovery State
Incomplete
Critical Event
No
Link Fault
No
Multiplexer State
Unknown
Parser Action
Unknown
Mode
Unknown
Supports
Unknown
OUI:
Unknown
Enter, Previous Screen (0), (n)ext page, (H)elp, E(x)it >
To configure the 802.3ah parameters for the UTP port, type an n and press <ENTER>.
Page 33