Honeywell MS-9200UDLSE Manual Do Utilizador

Programming

MS-9200UDLS   PN 52750:A    11/04/05

97

If an ACS annunciator is installed, press 1 while viewing Annunciator Screen #2 to 
select addresses for the ACS annunciators.  The following screen will be displayed:

Pressing the down arrow key will allow the programmer to view additional screens 
displaying Addresses 1 -31.  To select one or more addresses for the installed ACS 
annunciator(s), press the number key corresponding to the address in each screen.  
The display for the selected address will change from No to Yes.  Each press of the 
number key will cause the display to toggle between No and Yes.

The Onboard DACT (Digital Alarm Communicator/Transmitter) provides 
communication to a central station.  Pressing 2 while viewing the Option Module 
Screen will cause the following screens to be displayed:   

3.6.9.2.1  Onboard DACT Enable
To enable the onboard DACT, press 1 while viewing Onboard DACT Screen #1 
until the display reads Enabled Yes.  The display will toggle between Enabled Yes 
and Enabled No with each press of the key.

    ANNUNCIATOR
1=ADDRESS 1       YES
2=ADDRESS 2        NO
3=ADDRESS 3        NO

   OPTION MODULES
1=ANNUNCIATORS/UDACT
2=ON BOARD DACT
3=PRINTER/PC

Option Module Screen

    ON BOARD DACT
1=ENABLED        YES
2=PRIMARY PHONE
3=SECONDARY PHONE

    ON BOARD DACT
1=SERVICE TERMINAL
2=CENTRAL STATION
3=MANUAL DIAL MODE