Honeywell MS-9200UDLS Manual Do Utilizador

Programming

MS-9200UDLS   PN 52750:A    11/04/05

43

The MS-9200UDLS is completely field programmable and requires no special software 
skills.  While programming the MS-9200UDLS, the fire protection capabilities of the 
control panel are enabled. 

Site-specific programming may be accomplished in three ways:

• Autoprogramming Feature - This is a convenient method for quickly bringing 

the FACP addressable SLC devices on-line without the necessity of 
programming each device individually.  Refer to  "Autoprogram" on page 47 for 
a detailed description of Autoprogramming

• Manual programming or editing, using the FACP keypad or a PC keyboard
• Off-line Programming and Editing Feature - allows creation and editing of site-

specific custom programs using a Windows-based computer.  For programs 
requiring a large amount of data entry, this method may be preferred.  A PK-CD 
programming kit can be ordered for this purpose

The System All Normal screen will be displayed in a programmed system with no active 
alarms, troubles or supervisories, as illustrated below: 

Programming,  Read Status and Manual Dial mode can be entered while the panel is in 
any mode of operation.  If the panel is in alarm, the alarm condition must be 
acknowledged before entering any other mode.  To access any of the programming or 
read status features, the Enter or Mode key must be pressed, which will cause the LCD 
to display the following: 

Pressing 1, while this screen is being displayed, will cause the control panel to enter the 
Read Status Mode which allows the user to view the programmed features and status of 
the control panel  The Read Status feature is not password protected.  Refer to  "Read 
Status" on page 140 for a detailed description of this feature.

Pressing 2 will select user Programming Mode which may only be accomplished by an 
authorized person.  After pressing 2, a screen will prompt for a password.  After 
entering the correct password, the user may select from a list of programming options.

Pressing 3 will select the Manual Dial Mode which allows the user to enter a 
troubleshoot mode of operation.

The programmer can exit any mode by repeatedly pressing the keypad ESC (Escape) 
key until the display reads System All Normal.  Note that the data which is entered 
during Programming mode is not saved until the programmer exits this mode by 
repeatedly pressing the ‘ESC’ key.  If the Reset key is pressed or power is lost before 
exiting Programming mode, all data just entered will be lost.

HONEYWELL LIFE SAFETY
 SYSTEM ALL NORMAL
 10:00A 012102

1=READ STATUS MODE
2=PROGRAMMING MODE
3=MANUAL DIAL MODE