Honeywell MS-9200UDLS Manual Do Utilizador
Programming
Master Programming Level
82
MS-9200UDLS PN 52750:A 11/04/05
to view the second screen. Enter up to 20 characters in the second screen in the
same manner or just press Enter if a second banner line is not being entered. To
quickly clear the current banner, press the CLR key.
same manner or just press Enter if a second banner line is not being entered. To
quickly clear the current banner, press the CLR key.
To enter alphanumeric characters from the keypad, repeatedly press the appropriate
key until the desired character is displayed in the first position. For example, to
enter the letter B, press the 2 (ABC) key three times to toggle through the characters
1, A and B. Press the right arrow key to move the cursor one position to the right
and repeat the process to enter the next character. To enter a space, press the * (QZ)
key four times to place a blank in the desired position. When all characters have
been entered, press the Enter key to store the information. The display will return to
the Banner Screen.
key until the desired character is displayed in the first position. For example, to
enter the letter B, press the 2 (ABC) key three times to toggle through the characters
1, A and B. Press the right arrow key to move the cursor one position to the right
and repeat the process to enter the next character. To enter a space, press the * (QZ)
key four times to place a blank in the desired position. When all characters have
been entered, press the Enter key to store the information. The display will return to
the Banner Screen.
3.6.5.3 Time-Date
The control panel time and date can be changed by pressing 3 while viewing the
System Setup Screen #1. The following screen will be displayed:
System Setup Screen #1. The following screen will be displayed:
3.6.5.3.1 Time
To change the time, press 1 while viewing the Time-Date Screen. The following
screen will be displayed:
To change the time, press 1 while viewing the Time-Date Screen. The following
screen will be displayed:
A flashing cursor is located toward the top left of the display. Below the cursor is
the current time. To change the time, enter the two-digit hours followed by the two-
digit minutes. The cursor will move one position to the right each time a digit is
entered. After the last minutes digit is entered, the cursor will again move one
position to the right. At this point enter 1 for AM or 2 for PM. The display will
then return to the Time-Date Screen which will show the new time entry. If an error
is made while entering a digit, press the CLR key to delete the entire entry and
beginning again.
the current time. To change the time, enter the two-digit hours followed by the two-
digit minutes. The cursor will move one position to the right each time a digit is
entered. After the last minutes digit is entered, the cursor will again move one
position to the right. At this point enter 1 for AM or 2 for PM. The display will
then return to the Time-Date Screen which will show the new time entry. If an error
is made while entering a digit, press the CLR key to delete the entire entry and
beginning again.
SYSTEM SETUP
1=TROUBLE REM
2=BANNER
3=TIME-DATE
1=TROUBLE REM
2=BANNER
3=TIME-DATE
System Setup Screen #1
TIME AND DATE
1=TIME 10:00 AM
2=DATE 04-07-2002
3=CLOCK FORMAT 12HR
1=TIME 10:00 AM
2=DATE 04-07-2002
3=CLOCK FORMAT 12HR
Time-Date Screen #1
TIME AND DATE
1=DAYLIGHT SAVINGS
1=DAYLIGHT SAVINGS
Time-Date Screen #2
ENTER TIME
10:00 AM
1=AM 2=PM
1=AM 2=PM
Time Screen