Honeywell MS-9200UDLS Manual Do Utilizador

Programming

MS-9200UDLS   PN 52750:A    11/04/05

99

3.6.9.2.4  Service Terminal
The MS-9200UDLS can be programmed remotely from a PC using a modem and 
telephone line.  Information can also be retrieved from the FACP using the same 
method.  The Upload/Download option allows an operator to set the necessary 
parameters to allow the uploading and downloading of data between the FACP and 
PC.  The Service Terminal selection provides the means for entering these 
parameters.  

Pressing 1 while viewing On Board DACT Screen #2 will cause the following 
screens to appear: 

3.6.9.2.4.1  Panel ID
The Panel Identification Number is a 4-digit code (valid digits being 0 - 9 and A - F) 
that is used to identify the installed FACP.  It is important to program this code into 
the FACP the first time that downloading is performed so that the called Service 
Terminal can identify the control panel.  The factory default is 0000.

To program the Panel ID, press 1 while viewing Service Terminal Screen #1.  The 
following screen will be displayed: 

A flashing cursor will appear in the lower left corner of the display.  Enter a 4-digit 
code using the digits 0 - 9 and/or the letters A - F by entering the first character.  
Press the right arrow key to move the cursor to the second position and enter the 
second character.  Follow the same procedure to enter the remaining characters.  
After entering the fourth character, press the right arrow key and then press the 
Enter key to store the Panel ID number.

   ON BOARD DACT
1=SERVICE TERMINAL
2=CENTRAL STATION
3=MANUAL DIAL MODE

On Board DACT Screen #2

  SERVICE TERMINAL
1=PANEL ID      0000
2=TERMINAL 1
3=TERMINAL 2

  SERVICE TERMINAL
1=RING COUNT     3

      PANEL ID

4 CHARACTER 0-F