Viper 5902 Manual Do Utilizador

Configurations

29

© 2009 Directed Electronics. All rights reserved.

Placing the system into the remote pair mode

Open

1. 

 one or more of the vehicle doors. 

Turn

2. 

 the ignition to the On position.

Press

3. 

, release, then press and hold the Control button (on Con-

trol Center).
The control center LED begins to flash and the siren emits one 

4. 

chirp to confirm the system is in Pair mode, the Control button 
can be released. The system will stay in Pair mode for 60 
seconds or until the doors are closed or ignition turned off. 
The siren will emit one short and one long chirp when it exits 
remote pair mode.

Toggle 

1. to 

Remote Pair

 and press the menu wheel, the 

Remote 

Pair

 screen with on-screen instructions is displayed. 

Press

2.  

and 

hold the 

button. The remote’s LED flashes, then 

the siren chirps, and remote tones play to confirm pairing. The 

 screen is displayed before returning to the 

Adjustments feature menu screen.
If the remote does not learn the system ID it displays the 

3. 

 screen after the button is released before re-

turning to the Remote Pair screen. Press and hold the 
button to try again. If the siren chirps but remote tones are not 
played,  Press and hold the 

button to try again until the 

tones are played. If the siren does not chirp shortly after the 
remote LED begins flashing make sure the system is in remote 
pair mode.

Sensor Adjust 

Your Responder HD security with remote start system has a built in 
shock sensor used to detect intrusion attempts on your vehicle.  The 
sensor sensitivity can be adjusted to optimize your vehicle’s detection