Honeywell MS-9600UDLSE Manual Do Utilizador

Página de 208
30
MS-9600LS Series Manual — P/N 52646:B2  2/12/2010
Product Description
Accessories
The following table shows the ANN-80 connections to the FACP    
Programming
Following installation and wiring of the ANN-80 LCD annunciator to the FACP, the annunciator 
must added to the system via FACP programming.  Refer to the programming section titled “ANN-
BUS Options” on page 121 in thi
s manual for detailed programming information.  Select the LCD 
option for programming.
Trouble Response
If the ANN-80 is installed but the ANN-BUS is not enabled at the FACP, the ANN-80 will indicate 
a trouble condition by NOT turning on its AC Power indicator.  The LCD will also display Key Bus 
Trouble
 and the piezo will sound approximately once every 10 seconds.  Note that the FACP will 
provide no indication of an ANN-80 trouble.  
To clear the ANN-80 trouble condition, enable the ANN-BUS and program the address correspond-
ing to the address set on the ANN-80 at the FACP. 
If the Keyswitch on the ANN-80 is left in the unlocked position for more than 2 minutes, a trouble 
condition will be indicated at the FACP.  
ANN-S/PG Serial/Parallel Interface Installation
The ANN-S/PG Serial/Parallel Interface module allows the connection of a remote serial or parallel 
printer to the FACP for a real-time log of system events, detector status reports and event history.  
The module is provided with a plastic enclosure for surface mounting.  Proceed with the installation 
as described in the following:
1. Ensure that all power (AC and DC) has been removed from the FACP.
2. Connect the ANN-S/PG to the FACP as illustrated in Figure 1.7.  
3. Using the DIP switches on the back of the ANN-S/PG module, assign an ID number (address) 
to the module.
FACP
ANN-80 (TB1)
Terminal GND (-) on TB3
Terminal 1 (-)
Terminal PWR (+)TB3
Terminal 2 (+)
Terminal ACS on TB6
Terminal 3 (A)
Terminal ACS on TB6
Terminal 4 (B)
(-)
(+)
A
B
TB3
JP5
TB4
JP8
TB5
TB6
TB1
+ - + - + -
+ -
A B
Figure 1.7  ANN-S/PG Connection to FACP
ANN-S/PG Module
FACP
Cable Connectors for 
connection to printer
Parallel
Serial
ANN-BUS and power wiring are 
supervised and power-limited
24 VDC
nonresettable
ANN-BUS/
ACS BUS
96
00
lst
o
spg
.w
m
f