Honeywell MS-9600UDLSE Manual Do Utilizador

MS-9600LS Series Manual — P/N 52646:B2  2/12/2010

51

Installation

Removal of the keypad/display is normally not necessary.  If, however, it becomes necessary to 
replace the keypad/display, access the auxiliary trouble bus connectors at J16 and J17 or install the 
DACT-UD2 option module on J2, the Keypad/Display can be removed by inserting a Phillips 
screwdriver into each of the three holes located in the flexible covering of the Keypad/Display and 
loosening the three mounting screws.  Note that it is not necessary to disconnect the cables between 
the Keypad/Display and the main circuit board unless the unit itself is being replaced.  Carefully lift 
the Keypad/Display and rest the unit at the bottom of the main circuit board.

  

WARNING: RISK OF ELECTRICAL SHOCK AND EQUIPMENT DAMAGE
DISCONNECT ALL SOURCES OF POWER (AC AND DC) BEFORE INSTALLING OR REMOVING 
ANY MODULES OR WIRING.

NOTE: When installing the DACT-UD2, the main motherboard must be removed from the 
chassis.  Unplug the power supply cable from J1 before proceeding.

Keypad/Display Mounting 

Screw Access Hole

Keypad/Display Mounting 

Screw Access Holes

96

da

ct

1.

wm

f

standoff

screw

screw

screw

standoff

screw

screw

screw