Hotpoint bhwd 129 Manual Do Utilizador

Levelling your appliance correctly will provide it with 
stability and avoid any vibrations, noise and shifting du-
ring operation. If it is placed on a fitted or loose carpet, 
adjust the feet in such a way as to allow enough room 
for ventilation beneath the Washer-dryer.

1. Connect the supply pipe 
by screwing it to a cold 
water tab using a 
3/4 gas threaded connec-
tion (see figure). 
Before performing the 
connection, allow the wa-
ter to run freely until it is 
perfectly clear.

2. Connect the other end of 
the water inlet hose to the 
Washer-dryer, 
screwing  it  onto  the  ap-
pliance’s  cold  water  inlet, 
situated on the top right-
hand side on the rear of the 
appliance (see figure).

3. Make sure there are no kinks or bends in the hose.

!

  The water pressure at the tap must be within the 

values indicated in the Technical details table  
(on the next page).

!

  If the water inlet hose is not long enough, contact a 

specialist store or an authorised serviceman.

!

  Ensure that the supply taps are allowing water throu-

gh. Old taps may seize in the closed position and thus 
prevent water reaching the machine.

!

 Keep this instruction manual in a safe place for future 

reference. Should the appliance be sold, transferred or 
moved, make sure the instruction manual accompanies 
the Washer-dryer to inform the new owner as to its 
operation and features.

!

 Read these instructions carefully: they contain vital 

information on installation, use and safety.

1. Unpack the Washer-dryer.
2. Check whether the Washer-dryer has been damaged 
during transport. If this is the case, do not install it 
and contact your retailer.

3. Remove the 4 pro-
tective screws and the 
rubber bush with the 
respective spacer, situa-
ted on the rear of the 
appliance (see also the 
installation leaflet).
NB:The plastic spacers 
may fall down inside the 
machine once the bolt 
has been removed, and 

will not interfere with the operation of the machine.
4. Do not remove external bar.
5. Seal the gaps using the plastic plugs provided.
6. Keep all the parts: you will need them again if the 
Washer-dryer needs to be moved to another location.

!

 Packaging materials are not children’s toys.

Your machine may make a considerable amount of noise if 
the two front feet have not been adjusted correctly.
1. Install the Washer-dryer on a flat sturdy floor, wi-
thout resting it up against walls, furniture cabinets or 
other.

2. If the floor is not per-
fectly level, compensate 
for any unevenness by 
tightening or loosening 
the adjustable front feet 
(see figure); the angle of 
inclination, measured ac-
cording to the worktop, 
must not exceed 2°.