Dialogic IMG 1004 Manual Do Utilizador

Installation and Setup

Timing - IMG 1010

Topic Location: IMG 1010-Installation and Setup Guide > IMG 1010-Hardware

Installation

Timing

Before connecting the IMG 1010 to a network, it must be synchronized to a T1/E1

loop timing source such as a T1 or E1 span. The IMG 1010 will allow four different

loop timing clock sources to be connected to various inputs on the rear of the unit.

The IMG 1010 will allow a loop timing source to be connected to any of the 28 TDM

Bearer Ports and any of the four Signaling Ports on the rear of the chassis. The

Pinouts of the RJ48 connectors are shown in RJ 48 Connector Pinouts.

NOTE: The IMG 1010 cannot time off an atomic clock or similar. The TDM

inputs on the rear of the unit will only accept a loop timing clock source

from a T1, E1, or DS3.

IMG 1010 Back Panel