Fishman pocket blender Manual Do Utilizador
U
SING
M
ULTIPLE
O
UTPUTS
All the Pocket Blender's outputs can
be used simultaneously.
be used simultaneously.
This offers a basic combination of
signal routing and interfacing options
to accommodate most performance
and recording situations.
signal routing and interfacing options
to accommodate most performance
and recording situations.
E
FFECTS
L
OOPS
The Pocket Blender has two effects
loops for microphone and for
transducer signals. The sends can be
used as additional outputs. The
returns can be used as alternate
inputs. The transducer effects send
makes a perfect output signal for
electronic tuners.
loops for microphone and for
transducer signals. The sends can be
used as additional outputs. The
returns can be used as alternate
inputs. The transducer effects send
makes a perfect output signal for
electronic tuners.
input
microphone - ring
transducer - tip
transducer - tip
phantom
power
ground
lift
9V
effects loop
send
microphone
Made in the USA
transducer
return
send
return
output
AC ADAPTERS
FISHMAN 910-R,
ROLAND PSA SERIES
DIGITAL REVERB
M
ASTER
S
ECTION
Low Battery Indicator
If you use a battery to power the Pocket Blender, the LED will flash briefly when you plug into the input-
telling you that the unit is powering up.
telling you that the unit is powering up.
When the red LED lights with no signal present it is time to change the battery.
If the low battery light comes on while you're playing don't worry, you'll have enough power to get through
a gig. Just be sure to change the battery before the next time you use the preamp.
a gig. Just be sure to change the battery before the next time you use the preamp.
Master Volume Control
For the cleanest sound, set the master volume as high as you can without distorting your amp or mixer.
Mute Switch
Mutes all signals at the output section, so you can take breaks without changing any of your volume
settings.
settings.
With the mute engaged you can also silently disconnect the cable from your instrument without a loud
pop through the speakers.
pop through the speakers.
The mute switch is also useful with an electronic tuner. Plug the tuner into the transducer send and
engage the mute switch. You can now tune onstage without being heard through the speakers.
engage the mute switch. You can now tune onstage without being heard through the speakers.
R
EAR
P
ANEL
9-Volt Phantom Power Switch
Push the switch in for 9 volts bias voltage to the ring contact of the Input jack.
Push the 9-Volt phantom power switch in when you use a mini-electret microphone. Push the switch out
if you will use the Microphone Channel for a second pickup (piezo or magnetic)
if you will use the Microphone Channel for a second pickup (piezo or magnetic)
Input jack
(see Page 6)
Effects Loops
The microphone effects loop lets you insert outboard effects or signal processors into the Microphone
Channel.
The microphone channel send comes after the:
Channel.
The microphone channel send comes after the:
• Bass and treble controls
• Trim control
• HI cut and LO cut switches
• Phase switch
• Trim control
• HI cut and LO cut switches
• Phase switch
P o c k e t B l e n d e r
13
P o c k e t B l e n d e r
input
microphone - ring
transducer - tip
transducer - tip
phantom
power
ground
lift
9V
effects loop
send
microphone
Made in the USA
transducer
return
send
return
output
AC ADAPTERS
FISHMAN 910-R,
ROLAND PSA SERIES
POWER AMP AND SPEAKERS
STAGE AMP
STAGE AMP
MIXER
PICKUP SIGNAL ONLY
SENT TO STAGE MONITOR
DIRECT
BOX
8