Hoshizaki FD-1001MLH(-C) Manual Do Utilizador

67

9) Remove the object covering the infrared sensor. If you removed the infrared sensor 

housing from the base, replace it in its correct position, and secure it with the 
thumbscrew.

10) Move the power switch to the "OFF" position. Turn off the power supply, then proceed 

to "IV.D.. Mechanical Bin Control Check."

When the actuator paddle is not engaged the mechanical bin control is closed and the 
icemaker produces ice. 
a) Backup Bin Control: S1 dip switch 7 placed in the "ON" position, the mechanical bin 
control is used as a backup bin control safety. When ice fills the chute and engages the 
actuator paddle, the mechanical bin control opens and the control board shuts down the 
icemaker within 10 seconds and sounds a 9-beep alarm.
b) Stand-Alone Bin Control: S1 dip switch 7 placed in the "OFF" position, the 
mechanical bin control is used as a stand-alone bin control. The stand-alone application 
should only be used in Hoshizaki standard ice storage bin applications. When ice fills 
the chute and engages the actuator paddle, the mechanical bin control opens and the 
control board shuts down the icemaker within 10 seconds. 

S1 dip switch 7 in the "OFF" position on dispenser unit applications. See "II.C.4.a) 
Default Dip Switch Settings."

1) Make sure the power supply is off.
) Remove the strap connecting the spout to the chute assembly. See Fig. 8. Pull up the 

chute assembly slightly so that you can access the actuator paddle located in the top of 
the chute.

3) Move the power switch to the "ON" position.
4) Turn on the power supply to start the automatic icemaking process. 

Infrared Sensor

Infrared Sensor 
Housing

Lens

Infrared Sensor LED

Infrared Sensor LED

Thumbscrew

Chute Assembly

Actuator Paddle

Spout

Strap

Proximity Switch

Strap