Vermont Castings lhec30 Manual Do Utilizador

1

Installation Instructions

• 

Trim Kit Assembly (1) 

• 

Panel Access Bottom (1)

•

  Installation Instructions (1) (not shown)

Examine contents of shipping carton. If any parts are 
missing or damaged, contact your local dealer before 
starting installation.

NOTE: Remove and discard all plastic from packag-
ing.
CAUTION: Allow fireplace to cool if it has been in 
operation.
1.  For RN/RP models: Install the ON/OFF switch onto 

the right side of the trim kit by inserting the ON/
OFF switch with wiring assembly through the pre-
punched opening of bracket switch mounted on the 
right side of the trim kit, then connect the wiring to 
the valve. (Refer to Homeowner’s Manual)

2.  For the left side installation, relocate the bracket 

switch to the left side of the trim kit and repeat step 1.

3.  Remove top louvre from the fireplace by lifting and 

pulling out.

4.  Remove bottom louvre from the fireplace by remov-

ing the four (4) mounting screws.

5.  Install the trim kit onto the fireplace by hanging the 

whole trim kit assembly onto the front face of the ap-
pliance. (Fig. 2)

6.  Install the panel access bottom by hanging the side 

slots of the panel onto the two (2) pre-mounted 
shoulder screws on both bottom sides of the trim kit. 
(Fig. 3) Installation complete.

10008881  3/06  Rev. 1

�����
������������
���������

Trim Kit 

Asssembly

Fireplace

KT591

Fig. 2  Install trim kit.

�����
���������������������
�����
���������

KT592

Fig. 3  Install panel access bottom.

������
���������
��������
���������

CAR178

Fig. 1  Carton contents.

Romanesque Trim Kit 

Assembly

Romanesque 

Panel Access 

Bottom

Marquette Trim 

Kit Assembly

Marquette 

Panel Access 

Bottom