Uniden UBCT9 Manual Do Utilizador

SCAN

SCAN

SCAN

SCAN

If you want to stop on a channel during scanning, press 
HOLD/RESUME.
If you want to resume scanning, press HOLD/RESUME.

Direct channel access:
There are several ways to access a specific channel quickly.
1.   Press HOLD/RESUME. 
2.   Using the keypad, enter the channel number.
3.   Press HOLD/RESUME again.

Note:  You can also use the SCAN,    or    key instead of
 

  pressing HOLD/RESUME.

You can lockout any channel so it is not checked during normal scanning. You can also
restore the channel to scanning when you wish.

1.   Press HOLD/RESUME and enter the channel number by using the keypad, then press  
 

 

––– OR –––

1.   Press HOLD/RESUME and select the channel by using the
 

   or    key.

2.   Press L/O to lockout the channel. 
 

“L/O” appears on the display.

If the scanner keeps stopping on a particular channel due to noise or frequent 
transmissions, you may want to keep that channel from scanning.
1.   Wait until the scanner stops on the channel.
2.   Then press L/O.
3.   The scanner immediately resumes scanning because the locked out channel is no
 

longer in the scanning sequence.

Lockout Tips   Write down your locked-out channels and put in a convenient place in
 

case you need to restore them.

1.   Press HOLD/RESUME and select the channel number you want to restore by using the
 

keypad, the   or   key, then press HOLD/RESUME.

2.   Press L/O to unlock the channel. The “L/O ” disappears.

UBCT9 OM   23

12/11/07   3:53:41 PM