Uniden UBCT9 Manual Do Utilizador

The next available block appears on the display.

6.   Repeat step 5 until you have selected a size code for each
 

block.

 

For details about each size code, see “Fleet Map Size Codes”

 

in the Appendix.

A Hybrid system is simply a Type I system with some blocks designated as Type II blocks.
To program a Hybrid system, follow the steps listed in “Programming a User Fleet Map” in
the previous section. However, if you want a block to be Type II, select Size Code 

.

When you begin searching a trunking bank with a Hybrid Fleet Map, you will see both 
types of system IDs. That is, Type II IDs usually appear as an even number without a dash; 
Type I IDs appear as a three or four digit number, followed by a hyphen and a one or two 
digit number.

To properly track Motorola VHF and UHF trunked systems, you must enter what is known 
as the Base, Spacing Frequencies and Offset Channels for each system.
To find these out, check www.trunktracker.com and other web sites and frequency
resources.

To enter the Base, Spacing Frequencies and Offset Channel: (You can set up to three sets
of these, but almost all systems only use one set).

1.   Press and hold TRUNK for 1.5 seconds and select the bank you want to change.
2.   Use the    or    key to select 

 (Motorola Type2 VHF) or 

,(Motorola Type2

 

UHF), then press E.

3.   Use the    or    key to select 

  then press E.

4.   Use the keypad to enter Configuration Block Number(1-3).
5.   Use the keypad to enter a new Base Frequency, then press E.
6.   Press    the key and select 

 for entering the Spacing

 

Frequency.

7.   Use the keypad to enter a new Spacing Frequency, then
 

press E.

Note:   You can only enter within a range of 5-100 kHz, and 5 or
 

   12.5 kHz multiples.

8.   Press      the key and select 

 for entering the Offset

 

Channel.

UBCT9 OM   45

12/11/07   3:53:58 PM