KYOCERA ecosys fs-9130dn Manual Do Utilizador

The following table lists error messages that can be dealt with by the user. 

Warning  
image adapt

Printing job cannot be done in current resolution because there is not enough 
internal memory. Try adding more memory or changing resolution.

Warning  
low memory

The printer’s internal memory is running low due to the number of fonts and 
macros downloaded. Print a status page to see how much user memory is left, 
and try deleting unnecessary fonts and macros.

:Alarm buzzer sounds when an error occurs. Press [CANCEL] to stop the alarm buzzer.

;Ò

e-MPS not stored 
Press GO

The e-MPS job cannot be stored because RAM disk is disabled, RAM disk size is 
insufficient, hard disk is not installed, or hard disk is full. Press [GO] to print error 
report.

File not found 
Press GO

VMB: A VMB tray that was specified for output does not contain any jobs, or the 
VMB tray is not being used. Confirm the VMB tray.

If Auto Continue is set to On, printing will be automatically resumed after a preset 

period of time.

Format    error 
  Memory card

This message appears when the printer is in the ready state and the memory card 
is not formatted, and therefore cannot be read or written. 

Format error 
 Hard disk

Initialization (formatting) of the hard disk is required. Initialize the hard disk.

Hard disk err ## 
Press GO

Look at the error code given in place of ## and refer to the corresponding 

description given below.
01: Hard disk format error. If this error recurs even if the power has been turned 

off and then on, reformat the hard disk.

02: The disk system is not installed. Recheck the requirements for using the 

system and the devices.

04: There is no available hard disk space. Delete unnecessary files, etc., to free 

up space.

05: The specified file does not exist in the hard disk.
06: There is no memory available to the hard disk system. Increase the 

available memory.

10: Formatting is not possible because host data is being spooled on the hard 

disk.Wait until Ready is displayed, and then format.

20: The hard disk was installed in the incorrect slot (OPT). Reinstall the hard 

disk in a different slot (HDD).

85: VMB; Alias error (the alias setting was lost, or the VMB tray corresponding 

to the alias does not exist). Set the alias again.

97: Code job; The number of permanent code jobs reached the limit value, and 

no more can be saved. Either delete some unnecessary jobs, etc., or 
increase the limit.

99: A print job for the specified ID does not exist in the hard disk.

;Ò

;Ò

;Ò