Kompernass kh 4056 bicycle hoist Manual Do Utilizador

- 4 -

The best assembly results are achieved
when the ceiling brackets are located 
directly above the seat and handlebars.
Ensure there is sufficient clearance from
the side walls.

1. Measure the distance between the

handlebars and the seat on your 
bicycle.

2. Transfer this measurement to the cei-

ling, marking the required drill-holes
with the aid of a ceiling bracket. Drill
the required holes and insert the
plugs.

3. Make a stable square knot at one end

of the nylon cord and thread it
through the rear ceiling bracket 
(See Fig. 1).

4. Fasten both ceiling brackets to the

ceiling with the supplied cross-head
screws and plugs (see Fig. 1).

5. Connect the construction with the

cord in accordance with the block and
tackle principle. Run the cord through
the rollers in alternation, starting at
the ceiling bracket (see Fig. 3).

6. Run the cord through the safety 

mechanism in the ceiling bracket. 
(see Fig. 2).

7. Check that all screws are firmly tighte-

ned before using the bicycle hoist.

8. Assemble the wall mount. To do this,

lift the bicycle with the hoist and
mark the position for the wall mount.

9. After assembling the wall mount,

check all screw connections for tight-
ness again.

 Notice: Should the cord slip quickly

through your hands when raising or
lowering the bicycle, the increased
tempo of the cord itself will trigger
the brake and the cord will stop auto-
matically. 

Grease the rollers at regular intervals.
This will ensure that the bicycle hoist
moves easily. 

The packaging consists of 100% environ-
mentally friendly materials that can be
disposed of at local recycling collection
sites. Contact your municipal or commu-
nity administration for information on
disposal possibilities for metallic compo-
nents.

Kompernaß GmbH
Burgstrasse 21
D-44867 Bochum

www.kompernass.com

KH4056_IB_UK  19.09.2006  14:23 Uhr  Seite 4